Please confirm topic selection

Are you sure you want to trigger topic in your Anconeus AI algorithm?

Please confirm action

You are done for today with this topic.

Would you like to start learning session with this topic items scheduled for future?

Lumbar Disc Herniation
Updated: Oct 4 2016

Microdiscectomy

Preoperative Patient Care
Operative Techniques
E

Preoperative Plan

1

Identifies area of decompression on preoperative imaging

2

Execute surgical walkthrough

  • describe steps to the attending prior to the start of the case
  • describe potential complications and list steps to avoid them
F

Room Preparation

1

Surgical instrumentation

  • microscope or loupes
  • microdiscectomy set

2

Room setup and equipment

  • table
  • standard radiolucent table with Wilson frame vs. Jackson spine flat top table
  • C-arm
  • c-arm perpendicular to table
  • microscope (optional)
  • microscope in from opposite side of C-arm

3

Patient positioning

  • prone with arms at 90° max abduction and flexion to prevent axillary nerve injury
  • foam padding on chest so that nipples are pointing midline straight down
  • pads over ASIS and gel pads on knees
  • bilateral TED hose and SCDs
G

Dissect to Spinous Process

1

Palpate anatomic landmarks

  • identify the coccyx and the sacrum distally
  • identify the spinous processes proximally
  • palpate the iliac crests to identify the L4 vertebral level

2

Localize level of incision with anatomic or radiographic landmarks

  • insert a spinal needle slightly off of the midline
  • direct the spinal needle toward the disk of interest

3

Confirm disk level with fluoroscopy

4

Make midline incision.

  • midline incision with 10blade overlying the spinous processes between paraspinal muscles (erector spinae)
  • ~3-4cm in length for single level

5

Dissect subcutaneous tissue down to fascia

  • insert a cerebellar retractors for fascial exposure

6

Incise the fascia

  • make a vertical incision through the fascia on the side of the disk herniation
  • cauterize lumbodorsal fascia over spinous processes to just lateral of midline
H

Clear Lamina

1

Subperiosteal dissection with Cobb along spinous processes

2

Subperiosteal dissection of lamina

  • cranial to caudal down to lamina<br />

3

Place probe under lamina to identify level radiographically

4

Use Cobb to strip laterally along lamina until facet capsules identified but not violated

5

Place deep retractors for better visualization

I

Laminotomy and Ligamentum Flavum Resection

1

Remove spinous processes of operative levels with rongeur

  • bring in the microscope

2

Create working window

  • use a size 2 angled curet to create a plane between the ligamentum flavum and lamina of the cephalad vertebra
  • use a burr to thin the lamina then complete resection with Kerrison rongeurs
  • the window should extend cephalad from the interspace to the level of the pars interarticularis of the superior vertebra and caudad from the interspace to the superior most 3 mm of the inferior lamina
  • extend the laminotomy laterally to the medial edge of the facet joint complex
  • take a 45 degree Kerrison punch and remove the remaining bone to complete the laminotomy

3

Begin decompression

  • begin with decompression into canal into inferior half of lamina of cephalad vertebrae first with small curette
  • burr lamina and to thin and then complete resection with Kerrison rongeurs

4

Resect ligamentum flavum

  • dissect the ligament flavum from the medial edge of the facet
  • use a 2-0 angled curet to release adhesions between the facet joint capsule and the ligamentum flavum
  • resect the medial 3mm of the facet with a Kerrison punch
  • use Kerrison to resect caudad lamina from inferior vertebra
J

Foraminotomy and Nerve Root Identification

1

Perform foraminotomy

  • use a Kerrison punch and angle it out of the foramen of the traversing nerve root

2

Remove remaining ligamentum flavum with a rongeur

3

Visualize the dura

  • once visualized take a penfield 4 and identify the lateral edge of the traversing nerve root

4

Control epidural bleeding

  • use a combination of bipolar cautery and thrombin soaked gel foam to gain hemostasis

5

Mobilize the traversing nerve root toward the midline

  • this visualizes the disk space
  • place a nerve root retractor around the root and hold the nerve toward the midline
  • use bipolar cautery to coagulate epidural vessels over the disk herniation
K

Microdiscectomy

1

Excise disk

  • use a no. 15 blade to make a slit incision over the disk herniation
  • if the herniation contains lov viscosity material then aspirate the material into the suction tip
  • with high viscosity material use a micropituitary rongeur to remove the material
  • make several passes until all herniated material has been removed
L

Address Interoperative Complications including Dural Tear Repair

1

Perform water tight closure

  • use 4-0 nurulon to close primarily
  • place a fat graft to reinforce the dural closure
N

Wound Closure

1

Irrigation, hemostasis, and drain

  • flush out spine with saline bulb irrigation

2

Close Fascia

  • close fascia with 1-vicryl
  • need water tight closure and need to decrease dead space for hematoma

3

Superficial closure

  • subcutaneous with 2-0 vicryl
  • skin closure with buried 3-0 monocryl

4

Dressing

  • soft incision dressings over spine
Postoperative Patient Care
Private Note